qwen3.6-27b Users Report Repeated Tool Call Loops
Original: qwen3.6-27b tools call loop
A LocalLLaMA user reports qwen3.6-27b sometimes gets stuck repeatedly calling tools despite parameter tuning.
A Reddit user on r/LocalLLaMA says qwen3.6-27b can fall into repeated tool-call loops during use. They report spending two days adjusting parameters such as temperature and top-k without resolving the issue. The post is a troubleshooting question rather than a confirmed bug report, asking whether other local model users have seen similar behavior.
A user on r/LocalLLaMA reports a recurring problem with qwen3.6-27b in tool-use workflows: the model sometimes enters what appears to be an infinite loop of repeated tool calls. According to the post, the system can work correctly for a while, but at some point it may begin calling the same or similar tools over and over instead of stopping, producing a final answer, or moving the task forward. The user frames this as a practical reliability issue rather than a formal benchmark or release announcement.
Free shows the 3-line summary; Pro unlocks the full deep summary (~300 words) so you never have to click through.
See Pro plans →Want the original English / full article?
Read on r/LocalLLaMA top day →Summaries are AI-generated; the original article is authoritative.